COMMUNICATIONS >
UHF CB Radios >
Gme UHF Radios >
GME TX4610 5 WATT UHF RADIO + AXIS CH5T BLACK UHF FIBERGLASS ANT
The GME TX4610 5 WATT UHF RADIO + AXIS CH5T BLACK UHF FIBERGLASS ANT is currently out of stockCheck out Gme UHF Radios category for other Great deals.
GME TX4610 5 WATT UHF RADIO + AXIS CH5T BLACK UHF FIBERGLASS ANTENNA Product Details
In the Box:
Product SpecificationsGENERAL
Compliant Specification
Meets AS/NZS 4365 for radio communications equipment in the UHF citizen and personal radio service.
Frequency Range TX
476.425-477.4125 MHz
Number of Channels
80 UHF CB + 19 Receive only
Channel Spacing
12.5 kHz only
Operation Mode
Simplex Ch1 - 80 Semi Duplex Ch 1 - 8, 41 - 48
Scanning Speed
20 channels per second
Antenna Impedance
50 Ohms nominal
Nominal Battery Voltage
13.8 volts DC
Operating Voltage Range
10 - 15 volts DC
Overvoltage Protection
30 Volts DC max. At 18 Volts DC the RF power is reduced, and the words ‘Hi DC’ flash.
Overcurrent Protection
In-line 3A Fuse
Frequency stability
± 2.5 PPM
Modulation
FM
TRANSMITTER
RF Output
5.0 watts max
Spurious Emission
< - 26 dBm
Maximum Deviation
< ± 2.5 kHz at + 20 dB
Transmit Frequency Response
+ 6 dB per octave 300 Hz to 3 kHz + 1 - 3 dB
Current Consumption
< 260 mA muted 600 mA @ max. A.F Output
RECEIVER
Intermediate Frequencies
1st - 21.4 MHz 2nd - 450 kHz
Sensitivity
- 123 dBm for 12 dB SINAD unweighted
Selectivity
- 6 dB at ± 3.5 kHz, - 60 dB at ± 12.5 kHz
Intermodulation Immunity
73 dB
Blocking Immunity
100 dB
Spurious Response Immunity
70 dB
Audio signal to noise: 12.5Khz
> 45 dB
Current consumption
1.7 amps with 50 Ohm termination
Conducted Spurious Emission
< - 57 dBm
MECHANICAL SPECIFICATIONS
Dimensions
65 (H) x 165 (L) x 56 (D) mm
Weight
472 grams
Storage temperature
-10°C to +60°C
AXIS CH5T BLACK UHF 5DB FIBREGLASS CB ANTENNA 720MM HEIGHT FOR GME UNIDEN ORICOM FREE TRACKABLE POST AUSTRALIA WIDE
EXCELLENT ANTENNA FOR THE CITY AND COUNTRY
Packaged with 5.3M coax cable+ Connector (PL259). There is a fme connector on the end of the cable so you can just thread the cable through and then screw on the uhf pl259 connector to the end of it which is included for an easier fit. No soldering or cutting required. Excellent antenna for easy installation anywhere on the vehicle.
|